As 1100.101 1992 Technical Drawing — General Principles.pdf [top]
AS 1100.101-1992 provides the foundational "General Principles" for Australian technical drawing, establishing mandatory standards for sheet layout, line work, lettering, and projection methods. By aligning with international ISO standards, this document ensures clarity and consistency across engineering and drafting disciplines. For more details, visit Building CodeHub AS 1100.101-1992 Technical Drawing - General Principles
AS 1100.101-1992 serves as the primary Australian Standard for technical drawing, establishing essential general principles for clear, consistent communication in engineering and manufacturing. The standard covers crucial specifications, including drawing sheet layout, line conventions, lettering, and projection methods, aligned with international standards. For comprehensive details, see the Standards Australia.
As 1100.101 1992 Technical Drawing General Principles.pdf ((hot))
AS 1100.101-1992 serves as the foundational Australian standard for technical drawing, outlining general principles for engineering and architectural documentation across nine key sections. Reaffirmed in 2014, it ensures alignment with international ISO standards for both manual and CAD-based drafting. For detailed information, see this Scribd document Policy Commons AS 1100.101 1992 Technical drawing General principles.pdf
AS 1100.101-1992 establishes the fundamental principles for technical drawing in Australia, mandating uniformity through standardized line types, third-angle projection, and dimensioning practices. The standard specifies requirements for sheet layout, including title blocks and metric units (mm), to ensure clear communication across engineering and design disciplines. For detailed technical standards, you can search for the document through Standards Australia.
AS 1100.101-1992 serves as the primary Australian Standard for technical drawing, establishing mandatory guidelines for sheet layout, line work, lettering, and projection methods to ensure consistency. This standard, which applies to both manual and CAD drafting, aligns with international ISO standards for clarity in engineering and architectural documentation. For an overview of these standards, see the documentation on Scribd. AS 1100.101-1992 Technical Drawing - General Principles
The Australian Standard AS 1100.101–1992: A Practical Guide
Formal Bibliographic Reference
Australian Standard (Harvard/General Technical Style): AS 1100
Standards Australia. (1992). AS 1100.101—1992: Technical drawing—Part 101: General principles. Sydney, Australia: Standards Australia.
2. Drawing Sheets and Layout
Basic Rules
- All dimensions in millimetres (mm) (unless otherwise stated in title block).
- Do not repeat dimensions.
- Dimension lines should not cross other lines unless unavoidable.
- Use unidirectional text (readable from bottom or right of sheet).
Sheet Sizes (ISO A series)
- Preferred: A4 (210 × 297 mm), A3 (297 × 420 mm), A2, A1, A0.
- All drawings on a project should use the same size where possible.
8. Lettering
AS 1100.101 requires hand or CAD lettering to be:
- Gothic style: Single-stroke vertical or sloped letters.
- Uniform: Equal height and consistent spacing.
- Lower case vs Upper case: Upper case (Capitals) is preferred for titles and drawing numbers; Lower case is acceptable for general notes.
Minimum Heights:
- Drawing Title: 7mm
- Sub-titles: 5mm
- Dimensions/Notes: 3.5mm
2. Scope and Objective
The objective of AS 1100.101-1992 is to establish the rules and conventions for preparing technical drawings that are unambiguous and easy to interpret. It applies to all fields of engineering, architecture, and design where graphical representation is required.
The standard covers the fundamental elements of drawing creation, including:
- Drawing sheet sizes and layout.
- Line types and weights.
- Lettering and writing styles.
- Scales and projection methods.
- Dimensioning practices.