SNOMED International WebsiteSNOMED Forums
Page cover

Huawei Atn 910c -

Huawei ATN 910C — Comprehensive Handbook

Note: This handbook covers hardware, setup, configuration, troubleshooting, maintenance, network integration, security, and advanced use for the Huawei ATN 910C radio terminal (a VHF/UHF land mobile/air-ground communications terminal). It assumes a network-operator or integrator audience. If you need a formatted PDF, configuration snippets tailored to a specific network, or firmware-specific commands, say which region/firmware version and I'll adapt.

7. Comparison within ATN Series

| Model | Switching Capacity | Typical Role | |-------|------------------|---------------| | ATN 905 | 1.6 Gbit/s | Very small site/device | | ATN 910C | 8 Gbit/s | Compact edge node | | ATN 950B | 40–80 Gbit/s | Aggregation | | ATN 980C | >100 Gbit/s | Core access/aggregation | huawei atn 910c

20. Logs, Monitoring, and KPIs

  • Monitor: RF power, VSWR, BER (digital modes), RSSI, packet loss, CPU/memory, uptime.
  • KPIs: Availability, mean time between failures (MTBF), mean time to repair (MTTR), channel utilization.
  • Reporting: Configure NMS dashboards and periodic health checks.

2. Key Features

  • Compact Form Factor – Small, fanless design suitable for space-constrained outdoor/indoor deployments (e.g., street cabinets, poles, customer premises).
  • Wide Temperature Range – Operates reliably in harsh environments from –40°C to +65°C.
  • Low Power Consumption – Typically <25W, enabling deployment where power is limited.
  • MPLS-TP & Segment Routing – Supports deterministic, connection-oriented packet transport with OAM (Operations, Administration, and Maintenance).
  • Synchronous Ethernet (SyncE) & 1588v2 – Provides high-precision time and frequency synchronization for mobile base stations.
  • Resiliency – ITU-T G.8032 Ethernet Ring Protection (ERP), LAG, and MPLS-TP linear/ring protection.

7. Interfaces and Wiring

  • Front/Rear I/O: Power, RF, Ethernet (10/100/1000), serial RS232/RS485/TTL, GPIO, PTT/keying, audio I/O, GPS/TIMING (1 PPS), and external switching.
  • Wiring best practices: Use shielded cables for audio/serial; separate power and signal runs; follow color codes and pinouts in the manual.
  • Connector pinouts: Reference manufacturer pinout table for DB-9/DB-25/Ethernet RJ-45 mapping; observe handshake and grounding.