Huawei Usb Com 1.0 Frp Tool May 2026

The Huawei USB COM 1.0 FRP Tool is a specialized utility used to bypass the Factory Reset Protection (FRP) lock on Huawei and Honor devices. It primarily targets devices using Kirin chipsets that have been bricked or locked out after a factory reset. This tool works by communicating with the device in a low-level state known as USB COM 1.0 mode, often triggered via hardware test points. Core Functionality

FRP Bypass: Removes the Google account verification requirement after a hard reset.

Device Recovery: Can fix "dead" devices, boot loops, or phones stuck on the logo by flashing board software.

Low-Level Access: Utilizes the HiSilicon USB 1.0 interface to communicate with the phone when standard Fastboot or ADB modes are inaccessible. Common Tools & Drivers huawei usb com 1.0 frp tool

Several third-party tools utilize this mode to perform FRP unlocks:

R3 Pro Huawei USB COM 1.0 Tool: A popular free software for one-click FRP removal and bootloader unlocking through test point mode.

Unlock Tool / DC Phoenix: Professional-grade paid software often used by technicians to flash bricked Huawei phones in COM 1.0 mode. The Huawei USB COM 1

Huawei USB COM 1.0 Drivers: Essential for the PC to recognize the phone. Users often need to manually update a "USB SER" entry in Windows Device Manager to the correct "Huawei USB COM 1.0" driver. General Process for Use

Step 1: Install Drivers

General step-by-step (reasonable default)

  1. Install USB VCOM / Qualcomm / Preloader drivers on PC and reboot.
  2. Download and extract the tool to a folder. Run as Administrator.
  3. Power off the phone. Enter the required mode:
    • For EDL: hold appropriate key combo (varies) or use testpoint method.
    • For Preloader: connect while holding a button per device instructions.
  4. Connect the phone to PC via USB. Confirm a new COM port appears in Device Manager.
  5. In the tool select the detected COM port and the target operation (e.g., FRP remove).
  6. Start the operation and wait; do not disconnect the cable until complete.
  7. Reboot device and perform initial setup.

Tools for Huawei FRP Bypass (USB COM 1.0)

There isn't a single official tool called "Deep Piece," but this usually refers to specialized service tools that perform deep system wipes. Here are the most reliable tools used for this purpose:

Part 1: What is "USB COM 1.0"?

Most Android phones communicate with computers using standard ADB (Android Debug Bridge) or MTP (Media Transfer Protocol) drivers. However, when a Huawei phone is locked, standard ADB is disabled for security reasons. General step-by-step (reasonable default)

USB COM 1.0 is a special diagnostic mode. When a Huawei device is booted into this mode, it identifies itself to the computer as a serial COM port device rather than a standard smartphone. This low-level communication mode allows specialized software (FRP Tools) to send commands to the device's bootloader or modem partitions to remove the FRP lock.

Part 3: Step-by-Step Guide

Step 4: Reboot

If you had to short the test point, you may need to hold the Power button for 10-15 seconds to force a reboot. The phone should now boot up past the Google verification screen.

Best practices

If you want, I can provide model-specific steps (give your exact Huawei model and chipset), a checklist for drivers and downloads, or recommended official recovery firmware sources.

5. Risks and Caveats