Jungheinrich Error Code 0802 ((exclusive))

Based on technical documentation for Jungheinrich forklifts (particularly models like the ETV, EKS, EFG, etc.), the error code 0802 typically indicates a CAN bus (Controller Area Network) communication timeout or a receive error.

Here is the breakdown of the code and the recommended troubleshooting steps. jungheinrich error code 0802

Step 5 – Voltage check (truck ON)

• CAN‑H to ground: ~2.5 V to 3.5 V
• CAN‑L to ground: ~1.5 V to 2.5 V
• If both stuck near 0V or 12V/24V → short to ground or power.

Immediate steps (safe, quick checks)

1. Park safely and isolate power. Turn off the truck, remove key, and follow lockout/tagout procedures.
2. Visual inspection (5–10 minutes):
   • Check battery connections and main fuses for obvious damage.
   • Inspect cable harnesses between controller, inverter, and traction motor for loose connectors, corrosion, or chafing.
   • Look for water ingress or dirt on connectors and module housings.
3. Reconnect and re-power: After cleaning/drying connectors, reconnect firmly and power up to see if code clears.
4. Check for related codes: Note any other error codes — multiple codes help pinpoint the subsystem.

2. Wiring Harness Issues

• Chafing of the pedal-to-controller harness under the floor plate.
• Corroded or loose pins in the 6-pin connector near the pedal.
• Water ingress (common in cold storage or wash-down environments).

Q5: My pedal seems fine — could it be the control stalk?

Likely no. The forward/reverse stalk sends a binary direction request, not a proportional voltage. Error 0802 is 99% accelerator pedal or wiring-related. CAN‑H to ground: ~2

---