The Canon PIXMA G2010 resetter refers to tools or procedures used to clear the internal "waste ink counter," which triggers errors like 5B00 or P07 when the printer's ink absorber pads are theoretically full. While the printer might stop functioning to prevent ink leaks, you can often resume printing by resetting these software limits. Understanding the 5B00 Error
This error occurs because the printer tracks every cleaning cycle and ink flush. Once the limit is reached, it displays an "Ink Absorber Full" message and locks the device. A resetter—whether a software utility or a manual sequence—tells the printer's motherboard that the counter is back to 0%. Method 1: Manual Button Reset (No Software Required)
You can often clear the 5B00 error using only the printer's physical buttons by entering Service Mode. Enter Service Mode: Turn off the printer completely.
Hold the Stop button (red triangle), then press and hold the Power button. While still holding Power, release the Stop button. Press the Stop button 6 times.
Release the Power button. The green light should flash and then stay steady. Reset the Counter: Once in Service Mode, press the Stop button 5 times. Press the Power button once to confirm the reset.
The printer will print a page showing the counter (D-value) is now D=000.0. resetter printer canon g2010
Finish: Turn the printer off and then back on to exit Service Mode. Method 2: Professional Software Resetters
If manual button sequences fail, specialized software can provide a deeper reset.
Canon Service Tool (V3400/V4720/V6310): These are technician-level tools used to interface with the printer via a USB cable. In the tool, you select Main under the "Absorber Clear Ink Counter" section and click Set.
WIC Reset Utility: A popular third-party tool available at WIC Reset
that requires a purchased "Reset Key". It is often preferred for its user-friendly interface and support for Windows and macOS systems. Hardware Resetter: Devices like the MC-G02 Chip Resetter Go to product viewer dialog for this item. The Canon PIXMA G2010 resetter refers to tools
are used for newer G-series models that use maintenance cartridges with chips, allowing you to reset the chip's memory without replacing the unit. Method 3: Resetting Ink Levels After Refill
If your printer isn't throwing an error but is flashing a low ink warning after you've refilled the tanks, you need an ink level reset.
Initialization: Press the Setup button, then use the + button until "C" appears on the LCD. Press Black or Color to initialize the settings.
Bypass Warning: Alternatively, press and hold the Stop button for 5–10 seconds to bypass the low ink warning and resume printing. Important Maintenance Tip
Resetting the software counter does not physically empty the waste ink pads. If you reset the printer multiple times without cleaning or replacing the physical Ink Absorber Pads, ink may eventually leak out of the bottom of the device. For long-term use, it is recommended to eventually wash the pads in warm water and dry them before reinstallation. Number of initializations
Instead of physical detection, the G2010 uses an algorithmic estimation known as the Ink Absorber Counter. The firmware increments a value based on:
When this counter hits a threshold (often set at roughly 20,000-30,000 pages of theoretical waste), the firmware triggers Error 5B00. The printer is effectively bricked, refusing all commands. This is a safety mechanism to prevent ink from overflowing onto the user's desk, but it is also an artificial endpoint that often occurs well before physical saturation, especially if the user performs frequent cleaning cycles.
The resetter is a central figure in the Right to Repair debate. In many jurisdictions, the use of unauthorized service tools constitutes a violation of terms of service, though recent legislation (such as in the EU and select US states) is moving toward protecting the right to bypass software locks for repair purposes.
You can buy a Waste Ink Reset Key (small electronic dongle) for Canon G series. Plug it into the printer’s service port – resets counter automatically each time. Easier than software method.
Final note: Canon designed this reset for service centers only. Using it at home voids warranty if discovered, but many users do it successfully. Proceed at your own risk.