This is a detailed technical report examining Part 2 of the Standard Construction Specifications (SCS) for the Emirate of Abu Dhabi, primarily as issued by the Abu Dhabi Department of Municipalities and Transport (DMT) — historically known as the Department of Municipal Affairs (DMA).
Disclaimer: Specifications evolve. The current governing version is typically the Abu Dhabi SCS (General Specifications for Buildings and Civil Engineering Works) most recently updated circa 2018–2020. This report reflects the structural and technical intent of Part 2 as it standardly appears.
Given Abu Dhabi’s rapid infrastructure growth, this is a critical section.
If you are looking at an article discussing Standard Construction Specifications Part 2 Abu Dhabi, it likely highlights the tension between cost efficiency and durability.
The document is designed to stop contractors from cutting corners in a harsh environment. It forces the use of high-quality materials (like anti-corrosion coatings and specialized concrete additives) that might be optional elsewhere but are mandatory in Abu Dhabi to ensure infrastructure lasts 50+ years. standard construction specifications part 2 abu dhabi
In Abu Dhabi, Standard Construction Specifications (SCS) Part 2 typically refers to the detailed technical requirements and specific construction methods that support the general road and infrastructure frameworks. These standards are governed by the Abu Dhabi Quality and Conformity Council (QCC) and the Department of Municipalities and Transport (DMT). Overview of Part 2 Specifications
While Part 1 focuses on general road works, Part 2 contains the granular technical specifications required to execute and support those projects. It is often used in conjunction with the Standard Drawing Guidelines (TR-541 Part 2), which provides geometric and civil works drawings.
Key technical areas typically covered in Part 2 or its supporting geotechnical documents (like TR-509-2) include:
Geotechnical Requirements: Detailed standards for subsurface investigation, soil improvement, and foundation performance. This is a detailed technical report examining Part
Material Standards: Specific requirements for materials such as concrete, asphalt, fill, and backfill.
Civil & Structural Works: Technical specifications for masonry, plastering, painting, and waterproofing.
Infrastructure Systems: Standards for stormwater, subsoil drainage, and irrigation systems. Performance & Safety Criteria
Recent updates (such as those in TR-509-2) establish strict performance benchmarks for construction: 1.2 m requires shoring
Settlement Limits: Total settlement for road foundations must not exceed 25mm at 100% design load.
Safety Factors: A minimum safety factor against liquefaction of 1.25 is required.
In-situ CBR: Improved ground must have a California Bearing Ratio (CBR) of at least 10% at 5mm penetration. Compliance and Application
All contractors and consultants must refer to the latest versions available via the DMT E-Library. Failure to adhere to these specifications can impact the acquisition of necessary permits and approvals from the TAMM portal. STANDARD DRAWING GUIDELINE - PART 2 - Sign In
| Code/Regulation | Relation to Part 2 | |---------------------|------------------------| | Abu Dhabi International Building Code (ADIBC) 2021 | Part 2 provides earthwork provisions not detailed in ADIBC Chapter 18 (Soils and Foundations) | | Estidama Pearl Building Rating System (PBRS) | Earthwork surplus, dust control, and reuse of excavated material contribute to resource efficiency credits | | EAD Waste Management Rules | Mandatory segregation of C&D waste and disposal at approved landfills (e.g., Al Dhafra) | | Abu Dhabi Occupational Safety & Health Center (OSHAD) | Excavation depth > 1.2 m requires shoring; confined space protocols for deep excavations |
Unlike generic international specs (like AASHTO or BS), SCSP-2 incorporates local climatic conditions (extreme heat, sabkha soil, high water table) and locally available materials.