Yf-s201 Proteus Library |work| 95%
To work with the YF-S201 water flow sensor using Proteus for simulation and an Arduino or similar microcontroller for the actual implementation, you'll need to integrate a few components in your Proteus simulation and write appropriate code for your microcontroller. The YF-S201 is a popular water flow sensor that outputs a pulse signal proportional to the flow rate of water.
Part 5: Practical Example – Simulating YF-S201 with Arduino in Proteus
Let us walk through a complete simulation project. yf-s201 proteus library
Components Required (in Proteus):
- Arduino Uno
- YF-S201 (from your new library)
- 10kΩ resistor (pull-up – optional but recommended for noise-free simulation)
- LCD 16x2 (to display flow rate)
- Virtual Terminal (for debugging)
Technical Specifications
- Model: YF-S201 (also known as YF‑S201 or Hall Effect flow sensor)
- Operating Voltage: 5V to 18V DC (commonly 5V for Arduino)
- Maximum Current: 15 mA
- Output Signal: Square wave (digital pulses)
- Output Frequency: ( F = 4.5 \times Q ) (where ( Q ) is flow rate in Liters/minute)
- Pulse per Liter: Approximately 450 pulses per liter (450 Hz at 60 L/min)
- Duty Cycle: 50% ± 10%
- Working Flow Rate: 1 to 30 Liters/minute
بجرب
ردحذفi will try
ردحذفi'll try
ردحذفرائع
ردحذفلو سمحت انا واجهتني مشكله في التثبيت عايز حل
ردحذفحلو
ردحذفواااااو روعة
ردحذفtryyy
ردحذفGoog
ردحذفررلارلرى
ردحذفسرعه
ردحذفاللاباللالالاؤبلانتاءنتب
ردحذف000
ردحذفاهلا افضل لعبة
ردحذفجميل
ردحذفجميل
ردحذفkhuih
ردحذفgood
ردحذفa;vh
ردحذفحلوه
ردحذفgood
ردحذفGOOD
ردحذفروعة
ردحذفGood
ردحذفلالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالالا
ردحذفتحميل اللعبة جدا سهل
ردحذفشكرا
ردحذفwow
ردحذفYES
ردحذفgood
ردحذفهاي
ردحذفالعبة جميلة
ردحذفلم اثبتها بعد
ردحذفواو
ردحذفاروع لعبة
ردحذفحلو
ردحذفلعبة روعة
ردحذفروووووعه
ردحذفجامدة
ردحذفwooooooooooow
ردحذف،goodd
ردحذفرءع
ردحذفرائعة
ردحذفI well try
ردحذفتقلق
ردحذفGOOOOD
ردحذفGoooooooooooood
ردحذفok
ردحذفتم
ردحذف